Semiconductor and thin film applications of a quadrupole mass spectrometer

Commercial quadrupole mass spectrometer (QMS) residual gas analyzers became available in the late 1960s and have been popular in R&D laboratories, but have found limited use in semiconductor manufacturing. To sample at pressures above 10 −5 Torr with ppm sensitivity or better (relative to the total process pressure), differential pumping is usually required. The newly available, small, high-pressure QMS sensors can operate as high as 10–20 mTorr without differential pumping, but provide somewhat lower mass resolution and partial pressure sensitivity than a standard QMS. Applications in semiconductor manufacturing include equipment monitoring, process monitoring, and effluent analysis. Equipment monitoring can include qualification after preventative maintenance, rate-of-rise tests, and leak identification and detection. Usually the burning question is, Why won’t the vacuum chamber pump down? Other uses that are not usually considered include the qualification of replaceable parts: sputter cathodes, electrodes, lamps, shields, etc. In process monitoring, the key question is, Is this process running normally? A manufacturing monitor can be useful simply by providing a comparison between a well-behaved high-yield process and a marginal or failing process. Examples are given for physical vapor deposition (sputtering) processes, chemical vapor deposition, and plasma etching. The effluent from chemical vapor deposition and plasma etch processes can be analyzed to measure the efficiency of process gas utilization or to monitor the efficacy of abatement methods used for the removal of global warming gases.