Velocity and Size Characteristics of Liquid-Fuelled Flames Stabilized by a Swirl Burner

Velocity and droplet size characteristics of an unconfined quarl burner, of 16 mm quarl inlet diameter, have been measured with a phase-Doppler anemometer at a swirl number of about 0.29: the Reynolds number of the flow was 30000, based on the cold bulk velocity of 30.4 m s-1 and the hydraulic diameter. The atomization was achieved by shear between the swirling air and six radial kerosene jets and the resulting Sauter and arithmetic mean diameters were about 70 and 50 μm respectively after injection: velocity characteristics are presented for three 5 μm-wide size classes, 10, 30 and 60 μm. The flows correspond to no combustion and combustion of natural gas with a heat release of 8 kW supplemented by liquid kerosene flow rates sufficient to generate 21.6 and 37.2 kW : the gas equivalence ratio was 0.45 and atomized kerosene at two flow rates increased the overall ratios to 1.64 and 2.53. In non­-reacting flow, droplets 30 μm and smaller are sufficiently small to be entrained by the mean air velocity towards the central part of the flow and into the swirl-induced recirculating air bubble. The 60 μm droplets are able to travel through the bubble uninfluenced by turbulent fluctuations in the air and are ‘centrifuged’ away from the centreline, through acquisition of a mean swirl velocity component, so that a large proportion of the kerosene volume flow rate lies at the edge of the swirling jet. Because larger droplets are centrifuged to the outer part of the flow, whereas the smaller are entrained towards the centreline, the Sauter and arithmetic mean diameters are, by 1.22 quarl exit diameters downstream of the quarl, approximately 65 and 36 μm at the outer part of the flow and 35 and 12 μm near the centreline in the inert flow. In reacting flow, droplets evaporate rapidly in regions of elevated temperatures and hence no droplets are found within the flame brush and recirculation region. The aerodynamic response of each size class to the air velocity is similar to inert flow so that the majority of the kerosene flow is centrifuged away from the flame. On exit from the quarl, the evaporation and burning rates cause the Sauter and arithmetic mean diameters to be about 70 and 50 μm and 60 and 30 μm at the inner and outer edges of the spray respectively. By 1.22 quarl exit-diameters from the exit of the quarl, the air motion entrains droplets smaller than about 30 μm towards the flame, at the inner edge of the spray, so that the Sauter and arithmetic mean diameter