Experimental and theoretical investigations of benzoic acid derivatives as corrosion inhibitors for AISI 316 stainless steel in hydrochloric acid medium: DFT and Monte Carlo simulations on the Fe (110) surface

The inhibition efficiency of benzoic acid ( C1 ), para -hydroxybenzoic acid ( C2 ), and 3,4-dihydroxybenzoic acid ( C3 ) towards enhancing the corrosion resistance of austenitic AISI 316 stainless steel (SS) has been evaluated in 0.5 M HCl using weight loss (WL), open circuit potential (OCP), potentiodynamic polarization method, electrochemical impedance spectroscopy (EIS), and scanning electron microscopy (SEM) analysis. The results obtained from the different experimental techniques were consistent and showed that the inhibition efficiency of these inhibitors increased with the increase in concentration in this order C3 > C2 > C1 . In addition, the results of the weight loss measurements showed that these inhibitors followed the Villamil isotherm. Quantum chemical calculations and Monte Carlo simulations have also been used for further insight into the adsorption mechanism of the inhibitor molecules on Fe (110). The quantum chemical parameters have been calculated by density functional theory (DFT) at the B3LYP level of theory with 6-31G+(2d,p) and 6-31G++(2d,p) basis sets in gas and aqueous phase. Parameters such as the lowest unoccupied ( E LUMO ) and highest occupied ( E HOMO ) molecular orbital energies, energy gap (Δ E ), chemical hardness ( η ), softness ( σ ), electronegativity ( χ ), electrophilicity ( ω ), and nucleophilicity ( ) were calculated and showed the anti-corrosive properties of C1 , C2 and C3 . Moreover, theoretical vibrational spectra were calculated to exhibit the functional hydroxyl groups (OH) in the studied compounds. In agreement with the experimental data, the theoretical results showed that the order of inhibition efficiency was C3 > C2 > C1 . The corrosion inhibition efficiencies of benzoic acid ( C1 ), para-hydroxybenzoic acid ( C2 ), and 3,4-dihydroxybenzoic acid ( C3 ) have been evaluated in 0.5 M HCl toward protecting AISI 316 stainless steel (SS).