Influence of different thermopolymerization methods on composite resin microhardness

Additional heat polymerization in composite resins allows greater effective-ness of microhardness, flexural strength, fracture tough-ness, wear resistance, and increased color stability. 150 composite resin specimens were made using a 4 mm diameter and 2 mm thick bipartite steel matrix. Five resins composed of different compositions were tested (Brilliant Everglow/Coltene, Filtek One BulkFill/3M, Filtek P60/3M, Filtek Z350XT/3M, Filtek Z250XT/3M), and for each of them three types of polymerization were tested: light curing only (n=50); photopolymerization + autoclave thermopolymerization (n=50) and photopolymerization + microwave thermopolymerization (n=50). Each specimen was submitted to three indentations by means of the Vickers microhardness test, applying a load of 300gf, associated with the time of 15s. Data were analyzed descriptively by means of statistics, standard deviation and coefficient of variation and inferentially by the F test (ANOVA) in the comparison between groups. The margin of error used in statistical test decisions was 5%. The highest vicker microhardness averages were from the Control group (light curing only) on P60 (82.16) and Z250 XT (79.61) resins. The lowest averages were all verified on Brilliant Everglow resin in all polymerization methods studied: Photopolymerization (37.32), with microwave (43.80) and autoclave (45.12), followed by Bulk Fill 3M resin, ranged from 52.23 to 59.15. Both autoclave and microwave thermopolymerization methods showed similar behavior on the microhardness of the composites studied. Considering the resin type, there was a varied behavior compared to thermopolymerization, which increased the microhardness values for Brilliant Everglow resins (Coltene) and Filtek One Bulkfill (3M) and decreased for Filtek P60, Filtek Z350XT and Filtek Z250XT resins. Dentistry, composite resins, polymerization.