Radiopacity and physical properties evaluation of infiltrants with Barium and Ytterbium addition

Abstract Radiopaque properties in the infiltrant should be interesting for clinicians to feel more confident to indicate this treatment. Thus, the aim of this study was to evaluate the effect of the incorporation of barium and ytterbium particles on the physical properties of resin infiltrants. Groups were divided according to the addition of ytterbium oxide (Y) alone (30 or 40%) or Y with barium (YB) (15/15% or 20/20% respectively) in the Icon commercial infiltrant and in the experimental infiltrant base. Digital radiography (n=5), Microradiography (n=5), Microtomography (n=3), degree of conversion (n=5), water sorption (n=16), solubility (n=16), contact angle (n=16), flexural strength (n=16), elastic modulus (n=16) and Energy dispersive X-ray Spectroscopy (n=10) were performed. Analyses were performed using the R program, with a significance level of 5%, and microradiography and Microtomography analyses were evaluated qualitatively. In groups with 30 or 40% of ytterbium, radiopacity was higher or equal to enamel. Microradiography and Microtomography appear to have more radiopacity in groups with 40% (Y). Among the groups with no particle addition, those of the experimental infiltrant presented a higher degree of conversion than those of Icon®. In most groups, there was solubility below the ISO-recommended levels. The addition of particles resulted in higher viscosity. Groups with Icon had higher flexural strength and elastic modulus than groups with experimental infiltrant. The addition of 40% (Y) improved polymerization, had low solubility, and had greater radiopacity than enamel, however negatively affected the viscosity increasing then. Experimental groups with the base showed a higher water sorption than Icon groups. Resumo O objetivo desse estudo foi avaliar o efeito da incorporação de partículas de Bário e Itérbio nas propriedades físicas de infiltrantes resinosos. Os grupos foram divididos de acordo com a adição de Itérbio puro (30 ou 40%) ou Itérbio com Bário (15/15% ou 20/20% respectivamente) no infiltrante comercial Icon e no Infiltrante experimental base. Foram realizados os testes de: radiografia digital (n=5), microradiografia Transversa (n=5), microtomografia (n=3), grau de conversão (n=5), sorção (n=16), solubilidade (n=16), ângulo de contato (n=16), resistência flexural (n=16), modulo de elasticidade (n=16) e Espectroscopia por energia dispersiva (n=10). As análises foram realizadas utilizando o programa R, com nível de significância de 5