Soil microbial activity and community composition: Impact of changes in matric and osmotic potential

As saline soils dry, the salt in the remaining solution phase is concentrated and the microbes are subjected to both water and osmotic stress. However, little is known about the interactive effect of matric potential (MP) and osmotic potential (OP) on microbial activity and community structure. We conducted an experiment in which two non-saline soils, a sand and a sandy loam, were pre-incubated at optimal water content (for microbial activity) but different osmotic potentials achieved by adding NaCl. The EC of the saturated paste (ECe) ranged between 1.6 and 11.6 dS m −1 in the sand and between 0.6 and 17.7 dS m −1 in the sandy loam. After the 14-day pre-incubation, the soils were dried to different water contents: 25–35 g kg −1 in the sand and 95–200 g kg −1 in the sandy loam. Water potential (WP, the sum of osmotic + matric potential) ranged from −0.7 to −6.8 MPa in the sand and from −0.1 to −4.4 MPa in the sandy loam. After addition of ground pea straw to increase the concentration of readily available substrate, respiration was measured over 14 days and microbial community composition was assessed by phospholipid fatty acid analysis (PLFA) at the end of the experiment. In both soils, cumulative respiration at a given soil water content (WC) decreased with decreasing osmotic potential, but the effect of decreasing water content differed between the two soils. In the sand, cumulative respiration at the two lowest water contents (WC25 and WC28) was always significantly lower than that at the highest water content (WC35). In the sandy loam, cumulative respiration was significantly lower at the lowest water content (WC95) compared to the highest water content (WC200) only in treatments with added salt. The reduction of cumulative respiration at a given WP was similar in the two soils with a 50% reduction compared to the control (optimal water content, no salt added) at WP −3 MPa. In the sand at WP