A six-degree-of-freedom transducer for in vitro measurement of patellofemoral contact forces

A satisfactory design of the patellar component used in total knee arthroplasty and a general understanding of the effects of othopedic procedures require, in part, an accurate description of patellofemoral contact forces. Experimental determination of the contact stress distribution requires integration to estimate the contact forces. Due to complex patellar geometry, the determination of the components of the resultant load is difficult. Current techniques for the direct measurement of contact loads either report a single load component or require sequential experiments to fully describe the contact force. The present study describes the development of a six-degree-of-freedom patellofemoral force transducer. This transducer allows the simultaneous determination of the three components of the contact force with an increase in accuracy over available devices. The contact forces components are accurate to 1% of full scale (900 N anterior-posterior, ±200 N medial-lateral and inferior-superior). The location on the patella where the resultant force acts is determined to within 1 mm. Relative movement of this point as a function of either normal change in knee flexion angle or as a result of a typical orthopedic procedure is determined to within 0.1 mm. A protocol is presented that allows the contact forces to be determined for either the anatomically normal patella or a patella following total knee arthroplasty.