Elastic friction drive of surface acoustic wave motor

Importance of elastic deformation control to obtain large output force with a surface acoustic wave (SAW) motor is discussed in this paper. By adding pre-load to slider, stator and slider surfaces are deformed in a few tens nanometer. Appropriate deformation in normal direction against normal vibration displacement amplitude of SAW existed. By moderate deformation, the output force of the SAW motor was enlarged up to about 10 N and no-load speed was 0.7 m/s. To produce this performance, the transducer weight and slider size were only 4.2 g and 4×4 mm 2. By traveling wave propagation, surface particles of the SAW device move in elliptical motion. Due to the amplitude of the elliptical motion is 10 or 20 nm order, the contact condition of the slider is very critical. To control the contact condition, namely, the elastic deformation of the slider and stator surface in nanometer order, a lot of projections were fabricated on the slider surface. The projection diameter was 20 μm. In static condition, the elastic deformation and stress were evaluated with the FEM analysis. From this calculation and the simulation result, it is consider that the wave crest is distorted, hence the elasticity has influence on the friction drive condition. Elastic deformation of the stator surface beneath the projection from the initial position were evaluated. In 4×4 mm 2 square area, the sliders had from 1089 to 23,409 projections. Depression was independent to the contact pressure. However, the output force depended on the depression although the projection density were different. From the view point of the output power of the motor, the proper depression was independent to the projection density. Around 25 nm depression, the output force and output power were maximized. This depression value was almost same as the vibration displacement amplitude of the stator transducer.