Effect of Matrix Elasticity on the Continuous Foaming of Food Models

The aim is to understand the effect of matrix elasticity on continuous foaming using food models based on glucose syrup. This was modified by adding polyacrylamide (PAA) with 2% whey protein isolate (WPI) or Tween 80 as foaming agents. Foaming was conducted in a stirred column. Rotation speed N and gas-to-liquid flow ratio ( G / L ) were varied. Overrun, average bubble size d 32 , texture and stability were measured using densimetry, image analysis, and rheometry, respectively. Experimental results showed that 0.01% PAA did not modify the viscosity of 2% WPI models, but conferred low elastic behavior. PAA (0.05%) doubled matrix viscosity and drastically increased elasticity. The increase of elasticity became slower for further PAA addition. Foaming experiments demonstrated that theoretical overrun could not be achieved for inelastic WPI models in two cases: for high viscosity and low N , as dispersion effectiveness was reduced; for high G / L and N because of enhanced coalescence. Matrix elasticity was shown to increase overrun at constant viscosity for high G / L by enhancing interface stabilization. However, in elastic models, gas dispersion was more difficult and d 32 was higher than in inelastic fluids of similar viscosity. Finally, when the limiting step was dispersion, foaming was shown to be negatively affected by matrix elasticity.