Examination of the Spatially Heterogeneous Electroactivity of Boron-Doped Diamond Microarray Electrodes

Spatial variations in the electrical and electrochemical activity of microarray electrodes, fabricated entirely from diamond, have been investigated. The arrays contain ∼50-μm-diameter boron-doped diamond (BDD) disks spaced 250 μm apart (center to center) in insulating intrinsic diamond supports, such that the BDD regions are coplanar with the intrinsic diamond. Atomic force microscopy (AFM) imaging of the surface reveals a roughness of no more than ±10 nm over the array. Each BDD microdisk within the array contains polycrystalline BDD with a variety of different grains exposed. Using conducting-AFM, the conductivity of the different grains was found to vary within a BDD microdisk. Electrochemical imaging of the electroactivity of the microdisk electrodes using scanning electrochemical microscopy operating in substrate generation-tip collection mode revealed that, under apparently diffusion-limited steady-state conditions, there was a small variation in the response between electrodes. However, the majority of electrodes in the array appeared to show predominantly metallic behavior. For the electrodes that showed a lower activity, all grains within the microdisk supported electron transfer, albeit at different rates, as evidenced by studies on the electrodeposition of metallic silver, at potentials far negative of the flat band potential of oxygen-terminated polycrystalline diamond. The possibility of using these array electrodes for steady-state diffusion-limited measurements in electroanalytical applications is far-reaching. However, caution should be exercised in the kinetic analysis of voltammetric measurements, since wide variations in the electroactivity of individual grains are apparent when the potential is below the diffusion-limited value.