Development of Mould Flux for High Speed Thin Slab Casting

Mould powders impact the stability of the continuous casting process for steel at all casting speeds. The main functions of mould powder are to provide sufficient lubrication and to control the mould heat transfer between the solidifying steel shell and the copper mould. At higher casting speeds associated with thin slab casting, the role of the mould powder is even more important. Actual casting speeds for the thin slab caster at Corus IJmuiden are between 5.4 and 6 m/min; the production level is around 1.3 Mt/year (coils). It has been decided to increase the production of this caster to a level of 1.8 Mt/year (coils). In order to meet this demand, the steel in mould time has to be increased to approximately 85% and the maximum casting speed will be increased to 8 m/min. A collaborative project between Sumitomo Metal Industries (SMI) and Corus IJmuiden was initiated to develop mould powders which facilitate casting speeds up to 8 m/min at the thin slab caster. Main subjects of this project are: mould powder design, characterisation of mould powder and mould slag, trials at the pilot caster of Sumitomo and finally plant trials at the thin slab caster of Corus. A special point of attention is the condition to use mould powder as a granulated material at the thin slab caster. As a consequence, the characterisation work focussed on the choice of raw materials and on the corresponding phase relations at elevated temperatures. Typical of the developed mould powders are so‐called mild cooling properties which will result in a controlled mould heat transfer during casting. In this paper, several aspects of this joint project between Sumitomo and Corus will be described.