Understanding the foam stability mechanisms of complex formed by soy protein isolate and different charged polysaccharides: Air/water interfacial behavior and rheological characteristics

This study evaluated the foaming properties, the dynamic adsorption behavior at the air/water (A/W) interface and the foam rheological characteristics of complexes formed by soy protein isolate (SPI) and different charged polysaccharides, including chitosan (CS), guar gum (GUG) and gellan gum (GEG). The results showed that the SPI/CS10 had the highest initial foam volume (26.67 mL), which were 3.89 %, 100.08 % and 70.19 % higher than that of single SPI, SPI/GUG and SPI/GEG complexes, respectively. Moreover, three charged polysaccharides could all significantly improve the foam stability of complexes. Among them, foams stabilized by SPI/GEG10 were the most stable that the foam volume slightly changed (approximately 1 mL) and no drainage occurred throughout the whole recording process. The interfacial behavior analysis showed that SPI/CS10 had higher diffusion (Kdiff) and rearrangement rate (KR) but lower penetration rate (KP) at the A/W interface compared with single SPI, while SPI/GUG10 and all SPI/GEG complexes showed higher KR and KP but lower Kdiff. In addition, SPI/CS10 was beneficial to concurrently enhance the elastic strength and solid-like behavior of foam system, while all SPI/GEG complexes could improve the elastic strength of foam system but was not conducive to the solid-like behavior. [Display omitted] •Soy protein isolate/polysaccharide complex showed excellent foam stability.•Chitosan promoted diffusion and rearrangement of complex at air/water interface•Guar gum and gellan gum inhibited diffusion but promoted rearrangement of complex.•Chitosan and gellan gum significantly improved the structural strength of foams.