Surficial Homogenic Effect Enables Highly Stable Deep‐Blue Perovskite Light‐Emitting Diodes

The device performance of deep‐blue perovskite light‐emitting diodes (PeLEDs) is primarily constrained by low external quantum efficiency (EQE) especially poor operational stability. Herein, we develop a facile strategy to improve deep‐blue emission through rational interface engineering. We innovatively reported the novel electron transport material, 4,6‐Tris(4‐(diphenylphosphoryl)phenyl)‐1,3,5‐triazine (P‐POT2T), and utilized a sequential wet‐dry deposition method to form the homogenic gradient interface between electron transport layer (ETL) and perovskite surface. Unlike previous reports that achieved carrier injection balance by inserting new interlayers, our strategy not only passivated uncoordinated Pb2+ in the perovskite via P=O functional groups but also reduced interfacial carrier recombination without introducing new interfaces. Additionally, this strategy enhanced the interface contact between the perovskite and ETL, significantly boosting device stability. Consequently, the fabricated deep‐blue PeLEDs delivered an EQE exceeding 5 % (@ 460 nm) with an exceptional halftime extended to 31.3 minutes. This straightforward approach offers a new strategy to realize highly efficient especially stable PeLEDs. In this study, we innovatively proposed a sequential wet‐dry deposition technique to form the homogenic gradient interface between electron transport layer and perovskite surface by introducing the novel electron transport material, 4,6‐Tris(4‐(diphenylphosphoryl)phenyl)‐1,3,5‐triazine (P‐POT2T). Ultimately, we successfully fabricated efficient deep‐blue device delivering the stable emission at 460 nm with enhanced EQE of 5.01 % with superior half‐time of 31.3 min.