Improving the adhesion between epoxy coatings and aluminium substrates

Two different methods were followed to improve the adhesion and durability of the adhesion of a commonly used epoxy coating on an aluminium substrate. The first method was by application of a thin polymeric layer, having a thickness of around 10 nm, on the aluminium substrate prior to application of the epoxy coating. The functional groups in the polymers were chosen so as to be capable of chemisorption to the oxide surface and should also to be capable of being involved in the curing reaction of the epoxy resin. These polymers were poly(acrylic acid) (PAA), poly(ethylene-alt-maleic anhydride) (PEMah) and poly(vinyl phosphonic acid) (PvPA). An investigation of the interphasial region between the epoxy coating and the aluminium substrate in the final cured system showed that the polymeric layers were indeed involved in the curing reaction with the epoxy. For the poly(ethylene-alt-maleic anhydride)-based system, this resulted in the formation of a cured, mixed poly(ethylene-alt-maleic anhydride)/epoxy interphasial region between coating and substrate while for the two other polymers, a weakly cured interphasial region was formed. The second method of adhesion and durability improvement was by hydration of the aluminium substrates, performed by immersion in boiling water. This procedure results in the formation of a porous pseudoboehmite oxyhydroxide layer. The epoxy coating was found to be capable of fully penetrating into the layer. The adhesion of the epoxy coatings was tested initially and after exposure to 40 °C water and 40 °C 5% acetic acid. The poly(ethylene-alt-maleic anhydride)-based system resulted in a very good initial adhesion and durability in presence of water for the epoxy coating, while the systems based on the other two polymers did not. The pseudoboehmite-based system also resulted in very good initial adhesion and durability in the presence of water. None of the improved systems were, however, found to be able to withstand 40 °C 5% acetic acid and showed severe corrosion underneath the epoxy coating.