Optimizing twin-screw melt granulation: The role of overflight clearance on granulation behavior

[Display omitted] •New kneading elements were developed with reduced width and increased clearance.•New kneading elements reduce peak shear & dispersive mixing at kneading zone.•Higher barrel temperature & degree of fill is needed to compensate for lost shear.•Stable granules were formulated for thermolabile gabapentin by a thermal process. Twin-screw melt granulation (TSMG) relies on the dispersive and distributive mixing at the kneading zone for granule growth to happen highlighting the critical role played by the kneading elements in TSMG. Despite extensive research conducted on the impact of screw geometry in melt compounding, there is not enough literature for TSMG. Disc width for the kneading elements was 2 mm, contrary to the standard 5 mm. The objective of this study was to evaluate if varying overflight clearance (OC) can alter the paradigm for TSMG. The new elements reduce the peak shear at kneading zone however a higher barrel temperature and degree of fill (DoF) is required to compensate to attain similar granule attributes. The change in DoF was achieved through a combination of modified screw configuration to pre-densify powders before kneading and processing at a lower screw speed. Despite the higher barrel temperature, process optimization of thermally unstable gabapentin was carried out. Using the new elements, compressible granules (Tensile strength > 2 MPa) with low % GABA-L content were manufactured despite increasing OC to 0.4 mm. Granule stability at 40 °C, ambient humidity for 6 months indicated gabapentin was stable (% GABA-L ≪0.4 %) despite a high barrel temperature of 120 °C.