Rheology and microstructures formation of immiscible model polymer blends under steady state and transient flows

Viscoelastic properties of model immiscible blend were studied here under steady state condition at different initial conditions and transient flow conditions. The flow‐induced microstructure has been studied on these model blends. For this system, the elastic properties of the blend are mainly governed by the interface. Measurement of the dynamic modulus and of the first normal stress difference, both reflecting this enhanced elasticity, have been used to prove the blend morphology. The dynamic moduli after cessation of shear flow, the mean diameter of the disperse phase as generated by the shear flow, have been calculated using the model of Palierne. A procedure based on a direct fitting of the dynamic moduli with the model is compared with the one that uses a weight relaxation spectrum. On the other hand, the steady state normal stress data have been related to the morphology of the blend by means of Doi and Ohta model. The specific interfacial area is found to be inversely proportional to the ratio of interfacial tension over shear stress for the blend. The flow behavior during transient shear flow was also discussed. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 3519–3533, 2005