Composite patch reinforcement of cracked aircraft upper longeron: analysis and specimen simulation

The use of composite patches on cracked portions of metallic aircraft structures is an accepted means of improving fatigue life and attaining high structural efficiency. As more and more advanced composite materials are beng developed, the wider use of the repair technology is anticipated even for the reinforcement of primary aircraft structure. The objective of this work is to illustrate how the composite patch repair technology can be successfully applied to restore the structural integrity of cracked components. The Phosphoric Acid Anodize (PAA) surface treatment on aluminum when applied in conjunction with the AVI13/HV998 adhesive were essential for achieving the appropriate patch bonding strength. Such a process was done without immersing the component into the PAA tank; dismantling the component from the aircraft was not necessary. Boron/epoxy and carbon/epoxy patches were applied at room temperature to the 7075-T6511 cracked specimens and tested under fatigue simulating the load spectrum for the upper longeron attached to the access door of the electronic equipment bay. Considerable improvement in the fatigue life was observed after the repair. Equivalent flight test hours were increased from approximately two thousand hours at which the component fractured completely when not repired to twelve thousand hours when the repair was made with only a small amount of crack growth. A six times increase fatigue life is obtained. The laboratory developed technique has been applied to several in-service aircraft which have now been flown for more than 700 h without detection of crack growth.