Three-dimensional assessment of patellofemoral anatomy: Reliability and reference ranges

Three-dimensional (3D) imaging and analysis offer new possibilities in preoperative diagnostics and surgical planning. Simultaneous 3D analysis of the joint angles and the patellofemoral anatomy allow for a realistic assessment of bony pathologies in patients with patellofemoral complaints. This study aims to develop a standardized and validated assessment of the 3D patellofemoral morphology and to establish reference ranges. Thirteen patellofemoral anatomic landmarks were defined on 3D bone models of the lower limbs based on computer tomography data and evaluated regarding inter- and intra-observer variability. Further, 60 3D models of the lower limbs of young subjects without any previous knee operation/injury were assessed and rescaled reference values for relevant patellofemoral indices were obtained. The mean inter- and intra-observer deviation of all landmarks was below 2.3 mm. The interobserver intraclass correlation coefficient (ICC) was between 0.8 and 1.0 and the intra-observer ICC between 0.68 and 0.99 for all patellofemoral parameters. The calculated reference ranges are: Insall–Salvati index 1.0–1.4; patella tilt 6–18°; patella shift −4 to 3 mm; patella facet angle 118–131°; sulcus angle 141–156°; trochlear depth 3–6 mm; tibial-tuberosity to trochlear groove distance(TT-TG) 2D 14–21 mm; TT-TG 3D 11–18 mm; lateral trochlear inclination 13–23°; trochlear facet angle 43–65°. The demonstrated 3D analysis of the patellofemoral anatomy can be performed with high inter- and intra-observer correlation. Applying the obtained reference ranges and using existing 3D assessment tools for lower limb alignment, a preoperative 3D analysis and planning for complex knee procedures now is possible.