Is mercury in fluorescent lamps the only risk to human health? A study of environmental mobility of toxic metals and human health risk assessment

Although fluorescent lamps (FL) are extensively used worldwide, recycling rates in some countries are still low. If disposed of inappropriately and broken, FL can cause soil contamination. Hg toxicity in FL is extensively discussed in the literature; however, few studies address the other toxic metals present in the phosphorous powder of FL (PPFL). This paper presents a characterization of the environmental mobility with sequential extraction scheme (SES) of Cd, Cu, Hg, Mn, Ni, Pb, and Zn in PPFL, and modeling the potential risks to human health, in case of direct disposal in soils. An after thermal treatment waste was used for safety reasons. The SES method included five fractions, and the quantification was performed by flame atomic absorption spectrometry (FAAS). Human health risk assessment (HHRA) was conducted using RISC4® software. The PPFL showed the following mobility sequence: Cu (85%) > Ni (81%) > Hg (80%) > Zn (77%) > Cd (75%) > Mn (6%) > Pb (2%), which suggests that Cu, Ni, Zn, and Cd, besides Hg, could be of environmental concern in terms of availability. HHRA showed the potential hazard of Cd, for both children and adults, in the hypothetical scenario of vegetable ingestion, considering vegetables grown in soils contaminated with FL waste. The thermal treatment does not completely remove Hg from the matrix, and the residual Hg still poses a risk to children. These results show that Hg and Cd can be hazardous to humans and reinforce the importance of the correct disposal and treatment of PPFL. [Display omitted] •Mobility profile of Cd, Cu, Hg, Mn, Ni, Pb, and Zn in spent fluorescent lamps.•Cd, Cu, Hg, Ni, and Zn are the most labile metals.•Mn and Pb are the metals most strongly bound to the matrix.•Human health risk modeling in a scenario of soil contamination by spent lamps.•Cd and Hg can be hazardous to humans.