The effect of intensive grazing systems on the rising plate meter calibration for perennial ryegrass pastures

The rising plate meter (RPM) is used to measure grass height, which subsequently is used in a calibration equation to estimate herbage mass (HM), an important parameter for optimization of feed management in grazing systems. The RPM is placed on the sward and measures the resistance of the sward toward the plate, which depends not only on grass length, but also on sward structure. The accuracy of the calibration equation for the RPM to estimate HM across grazing systems, however, has not yet been evaluated. Therefore, our aim was to analyze the effect of intensive grazing systems on RPM calibration for perennial ryegrass pastures. To do so, we studied 2 grazing systems: compartmented continuous grazing (CCG) and strip grazing (SG), which differ in key grazing characteristics, such as pre- and post-grazing heights and period of regrowth, that may influence tiller density and vertical flexibility of the sward. The experiment was performed from April until October in 2016 and 2017 with 60 dairy cows, at a fixed stocking rate of 7.5 cows per hectare. To calibrate the RPM, 256 direct measurements of HM >4 cm (i.e., above stubble) were collected by cutting and weighing plots of grass for CCG and SG. Our main interest was in the HM above stubble because this is consumed by cows. Herbage mass