Removal of TiO2 nanoparticles from water by low pressure pilot plant filtration

Rising use of nanoparticles in manufacturing as well as in commercial products bring issues related to environmental release and human exposure. A large amount of TiO2 nanoparticles will eventually reach wastewater treatment plants. Low pressure membrane filtration has been suggested as a feasible treatment of water streams. This study investigated first at laboratory scale the influence of: i) membrane material, ii) pore size and iii) water chemistry on nTiO2 removal. TiO2 retention was governed by the cake layer formation mechanism and significant retention of nanoparticles was observed even for filters having considerably larger pores than nTiO2. PVDF showed a great potential for nTiO2 rejection. Additionally, filtration pilot plant experiments were carried out using PVDF membranes (0.03 and 0.4μm pore size). The release of nTiO2 in the pilot scale filtration system was always above the instrumental detection limit (>1.5μg/L) and in most cases below 100μg/L regardless of the pore size and applied conditions. The nTiO2 membrane breakthrough predominantly occurred in the first few minutes after backwashes and ceased when the cake layer was formed. Ultrafiltration and microfiltration were comparable with rejection of nTiO2 above 95% at similar permeate flow rates. Nevertheless, ultrafiltration is more promising than microfiltration because it allowed longer operation times between backwash cycles. [Display omitted] •Nano-TiO2 retention depends strongly on the aqueous media.•The combination of humic acid and bicarbonate highly increased the nano-TiO2 release.•Nanoparticle rejection was generally above 95% in a filtration pilot plant.•2.3g of NPs could be released when treating 31m3 of tap water with 2mg/L nTiO2.