A simple and efficient feeder-free culture system to up-scale iPSCs on polymeric material surface for use in 3D bioprinting

The 3D bioprinting and cell/tissue printing techniques open new possibilities for future applications. To facilitate the 3D bioprinting process, a large amount of living cells are required. Induced pluripotent stem cells (iPSCs) represent a promising cell source for bioprinting. However, the maintenance and expansion of undifferentiated iPSCs are expensive and time consuming. Therefore, in this study a culture method to obtain a sufficient amount of healthy and undifferentiated iPSCs in a short-term period was established. The iPSCs could be passaged for twice on tissue culture polystyrene (TCPS) dish with the conditional medium and could adapt to the feeder-free environment. Feeder-free dishes were further prepared from chitosan, chitosan-hyaluronan, silk fibroin, and polyurethane (PU1 and PU2) two-dimensional substrates. The iPSCs cultured on the chitosan substrates showed a higher proliferation rate without losing the stemness feature. Among the different materials, PU2 could be prepared as a thermoresponsive hydrogel, which was a potential ink for 3D bioprinting. The iPSCs cultured on PU2 substrates well survived when further embedded in PU2 hydrogel. Moreover, PU2 hydrogel printed with iPSCs remained structural integrity. The use of PU2 hydrogel to embed iPSCs reduced the injury to iPSCs by shear stress. These results indicate that iPSCs could be expanded on chitosan or PU2 membranes without the feeder layer and then printed in PU2 hydrogel. The combination of these steps could offer a new possibility for future applications of iPSC-based 3D bioprinting in tissue engineering. •A simple and efficient feeder-free culture system of iPSCs is developed.•iPSCs cultured on chitosan show stemness and a higher proliferation rate.•iPSCs embedded in PU hydrogel can be printed as a 3D cell-laden scaffold.