Influence of pH, temperature, salinity, and dissolved organic matter on the photolysis of 2,4-dinitrotoluene and 2,6-dinitrotoluene in seawater

In this study, the influence of salinity, nitrate, pH, temperature, and dissolved organic matter on the rate of photolysis of 2,4-dinitrotoluene (2,4-DNT) and 2,6-dinitrotoluene (2,6-DNT) in marine, estuary, and laboratory-prepared waters was measured. Photochemical degradation was studied using a Suntest CPS+ registered solar simulator equipped with various filters designed to select specific regions of the solar spectrum. Degradation rates of the compounds were determined using HPLC analysis, and product formation was determined using LC/MS. DNT photolysis rates were influenced by the wavelength of the light irradiating the compound; 295, 305, and 320nm long-pass filter exposures produced similar degradation rates while 385 and 395nm filter exposures produced minimal or no degradation. Under the 295-nm filter, first-order DNT degradation rate constants increased with increasing salinity for both natural seawater and artificial seawater. The 2,6-DNT rate constants did change significantly when the pH (7.2 to 8.1), temperature (10 to 32 degree C), and nitrate (up to 4mM) were varied over the range of values found in marine waters. Similar results were found for 2,4-DNT, except for temperature where the rate constant increased slightly with increasing temperature. The addition of dissolved organic matter (up to 10mg/L) to ultrapure water, artificial seawater (salinity=9), and natural seawater enhanced the photolysis of 2,6-DNT, while it only enhanced the photolysis of 2,4-DNT in the ultrapure and artificial seawater (salinity=9). Products formed by 2,4-DNT photolysis in natural seawater were 2,4-dinitrobenzaldehyde, 2,4-dinitrobenzylnitrile, and 2-amino,4-nitrobenzoic acid. The photolysis of 2,6-DNT in natural seawater formed 2,6-dinitrobenzaldehyde, 2,6-dinitrobenzyl alcohol, and 2,6-dinitrobenzylnitrile.