Field trial of seismic recording using distributed acoustic sensing with broadside sensitive fibre‐optic cables

ABSTRACT Distributed acoustic sensing is an emerging technology using fibre‐optic cables to detect acoustic disturbances such as flow noise and seismic signals. The technology has been applied successfully in hydraulic fracture monitoring and vertical seismic profiling. One of the limitations of distributed acoustic sensing for seismic recording is that the conventional straight fibres do not have broadside sensitivity and therefore cannot be used in configurations where the raypaths are essentially orthogonal to the fibre‐optic cable, such as seismic reflection methods from the surface. The helically wound cable was designed to have broadside sensitivity. In this paper, a field trial is described to validate in a qualitative sense the theoretically predicted angle‐dependent response of a helically wound cable. P‐waves were measured with a helically wound cable as a function of the angle of incidence in a shallow horizontal borehole and compared with measurements with a co‐located streamer. The results show a similar behaviour as a function of the angle of incidence as the theory. This demonstrates the possibility of using distributed acoustic sensing with a helically wound cable as a seismic detection system with a horizontal cable near the surface. The helically wound cable does not have any active parts and can be made as a slim cable with a diameter of a few centimetres. For that reason, distributed acoustic sensing with a helically wound cable is a potential low‐cost option for permanent seismic monitoring on land.