Metal- and Ligand-Accelerated Catalysis of the Baylis−Hillman Reaction

The Baylis−Hillman reaction, the coupling of an unsaturated carbonyl compound/nitrile with aldehydes, is a valuable reaction but is limited in its practicality by poor reaction rates. We have endeavored to accelerate the reaction using Lewis acids and found that while conventional Lewis acids gave reduced rates group III, and lanthanide triflates (5 mol %) gave increased rates. The optimum metal salts were La(OTf)3 and Sm(OTf)3, which gave rate accelerations (k rel) of approximately 4.7 and 4.9, respectively, in reactions between tert-butyl acrylate and benzaldehyde when using stoichiometric amounts of DABCO. At low loadings of DABCO (up to 10 mol %), no reaction occurred due to association of DABCO with the metal. Use of additional ligands to displace the DABCO from the metal was studied, and the rate of reaction was found to increase further in most cases. Of the ligands tested, at 5 mol %, (+)-binol gave one of the largest rate accelerations (3.4-fold) and was studied in more detail. It was found that reactions occurred even at low DABCO concentration so that here the Lewis base and Lewis acid were able to promote the reaction without interference from each other. While the (+)-binol (and other chiral ligands) failed to provide any significant asymmetric induction, a substantial nonlinear effect was observed with binol. Thus, use of racemic binol gave no effect on the rate. In seeking to maximize the rate attainable, more soluble (liquid) ligands were studied. Diethyl tartrate and triethanolamine gave rate enhancements of 5.2× and 3.5× at 50 mol %, respectively, versus 1.5× and 2.3× at 5 mol %. The best protocol was to use 100 mol % DABCO, 50 mol % triethanolamine, and 5 mol % La(OTf)3. This gave overall rate accelerations of between 23-fold and 40-fold depending on the acrylate and approximately 5-fold for acrylonitrile. A simple acid wash removed the reagents, leaving the product in the organic phase. While triethanolamine accelerated the reaction without the lanthanum triflate (18−22-fold at 80 mol %), the reaction in the presence of the metal salt was faster. The system was tested synthetically on various substrates and found to give good rate accelerations with both activated (benzaldehyde and p-nitrobenzaldehyde) and less activated aldehydes (anisaldehyde and cyclohexanecarboxaldehyde) with acrylates. The limited amount of dimerized acrylate in the latter reactions is noteworthy and should extend the range of substrates that can be made by the Bay