Sensitivity of a Greenland ice sheet model to ice flow and ablation parameters : consequences for the evolution through the last climatic cycle

Sensitivity experiments are conducted to test the influence of poorly known model parameters on the simulation of the Greenland ice sheet by means of a three dimensional numerical model including the mechanical and thermal processes within the ice. Two types of experiments are performed: steady-state climatic conditions and simulations over the last climatic cycle with a climatic forcing derived from the GRIP record. The experiments show that the maximum altitude of the ice sheet depends on the ice flow parameters (deformation and sliding law coefficients, geothermal flux) and that it is low when the ice flow is fast. On the other hand, the maximum altitude is not sensitive to the ablation strength and consequently during the climatic cycle it is driven by changes in accumulation rate. The ice sheet extension shows the opposite sensitivity: it is barely affected by ice flow velocity and the ice covered area is smaller for large ablation coefficients. For colder climates, when there is no ablation, the ice sheet extension depends on the sea level. An interesting result is that the variations with time of the altitude at the ice divide (Summit) do not depend on the parameters we tested. The present modelled ice sheets resulting from the climatic cycle experiments are compared with the present measured ice sheet in order to find the set of parameters that gives the best fit between modelled and measured geometry. It seems that, compared to the parameter set most commonly used, higher ablation rate coefficients must be used.