Removal of suspended clay from water using transmembrane pressure pulsed microfiltration

Transmembrane pressure pulsing (TPP) uses the frequent and periodic reversal of the transmembrane pressure to reduce flux resistances due to membrane fouling. This study examined the effect of TPP on the microfiltration of simulated drinking water (hydrated aluminum silicate solution). Solutions of kaolin clay (0.1–4.0 μm particles, at an approximate concentration of 500 mg l −1 and a turbidity of 402±17 NTU, 0.5 mM CaCl, 2.0 mM NaHCO 3, pH 7.5–7.8) were microfiltered with polyethersulfone (PES) 0.16 μm microfiltration membranes at an operating pressure of 30 kPa. Crossflow shear rates were varied between 165 and 1490 s −1. Pulse frequency was varied between 0.3×10 −2 and 2 Hz, and pulse amplitude was varied between −3 and −16.5 kPa. It was found that the crossflow shear rates did not significantly effect the non-pulsed permeate flux. An optimum pulse amplitude of about 10 kPa was necessary to maximize the permeate flux for pulse frequencies between 0.3×10 −2 and 2.0 Hz. To insure a reduced solute flux, pulse frequencies less than 0.1 Hz were required. These results indicate that TPP can significantly reduce membrane fouling by inorganic particulate materials that are potentially important constituents of natural waters without negatively impacting the rejection of sub-micron particles due to interactions with material accumulated on the membrane.