Influence of Hot Extrusion Temperature on the Microstructure and the Mechanical Properties of (ABOw + WO3p)/Al Hybrid Composites

The (ABOw + WO 3 p)/Al hybrid composite was fabricated by squeeze casting and subsequently hot extruded at temperatures that varied from 440°C to 560°C. The microstructures of extruded composites were examined by scanning electron microscopy and transmission electron microscopy techniques. The results show that ABOw aligns along the extrusion direction after the hot extrusion process. The aspect ratio of ABOw in extruded composites is lower than that of as-cast composite. The aspect ratio of ABOw in extruded composites increases with the increase of extrusion temperature. The larger WO 3 p particles are broken into smaller particles during the extrusion process. The transmission electron microscopy (TEM) images show that hot deformation leads to high dislocation density at a lower deformation temperature and leads to grain recovery and recrystallization at a higher deformation temperature. The strength of extruded composites increases first and then decreases with the increase of extrusion temperature, and it reaches maximum value at 500°C. The elongation of extruded composites increases with the increase of extrusion temperature.