A study on the SLS manufacturing and experimenting of TiB2-CuNi EDM electrodes

Purpose – This work aims to investigate the direct production of electrical discharge machining (EDM) electrodes by means of the selective laser sintering (SLS) technique using a new non-conventional metal-matrix composite material (TiB2-CuNi). The influence and optimization of the main SLS parameters on the densification behavior and porosity is experimentally studied. EDM experiments are also performed to evaluate the electrodes performance. Design/methodology/approach – The new EDM electrode material used was a powder system composed of TiB2 and CuNi. Making use of a designed systematic experimental methodology, the effects of layer thickness, laser scan speed and scan line spacing were optimized, where aspects such as densification behavior, porosity and surface morphology of the samples were analyzed through microstructural and surface analysis. EDM experiments were conducted under three different regimes in order to observe the electrodes behavior and performance. The results were compared with copper powder electrodes manufactured by SLS and EDMachined under the same conditions. Findings – The experimental results showed that the direct SLS manufacturing of composite electrodes is feasible and promising. The laser scan speed has a high effect on the densification behavior of the samples, while the effect of scan line spacing on the porosity is more visible when the overlapping degree is considered. Surface morphology was not affected by the scan line spacing, whereas balling phenomenon was reported, regardless of the scan line spacing. The EDM results showed that the TiB2-CuNi electrodes had a much superior performance than the copper powder electrodes made by SLS, regardless of the EDM regime applied. Research limitations/implications – Generally, the machine tool itself promotes some restrictions to the SLS process optimization. It is normally attributed to the characteristics of the laser type and the amount of energy that can be delivered to the powder bed. The present investigation could not cover all the optimization potential involved with the studied material due to limitations of the SLS machine tool used. Originality/value – Significant results on the direct SLS manufacturing of a new non-conventional composite material, which has a great technological potential to be used as an EDM electrode material, are presented. Valuable guidelines are given in regard to the SLS optimization of TiB2-CuNi material and its performance as an EDM electrod