Multi-objective optimization of Stinger PDC cutter breaking rock parameters under intrusion-cutting action using Taguchi-based gray relational analysis
To enhance the efficiency of the Stinger Polycrystalline Diamond Compact (PDC) cutter in breaking hard rocks, this study focuses on optimizing the cutter intrusion-cutting rock breaking parameters. A numerical calculation model for the rotational breaking of granite by a Stinger PDC cutter was estab...
Gespeichert in:
Veröffentlicht in: | Review of scientific instruments 2024-09, Vol.95 (9) |
---|---|
Hauptverfasser: | , , , , , , , |
Format: | Artikel |
Sprache: | eng |
Schlagworte: | |
Online-Zugang: | Volltext |
Tags: |
Tag hinzufügen
Keine Tags, Fügen Sie den ersten Tag hinzu!
|
Zusammenfassung: | To enhance the efficiency of the Stinger Polycrystalline Diamond Compact (PDC) cutter in breaking hard rocks, this study focuses on optimizing the cutter intrusion-cutting rock breaking parameters. A numerical calculation model for the rotational breaking of granite by a Stinger PDC cutter was established. A comprehensive statistical examination was performed to assess the influence of various factors on intrusion ability (IA), tangential force (TF), and mechanical specific energy (MSE). The Taguchi method was used to determine the optimal settings for each factor, while analysis of variance was employed to assess the significance and relative impact of these factors on the target outcomes. In addition, the multi-objective function was optimized using the gray relational analysis method. The primary process parameters obtained for the various performance characteristics are the cone top angle (α), the cone top radius (r), the cutter diameter (d), the cutter back inclination angle (β), and weight on bit (P). The impact ratios of these parameters are 6.20%, 7.66%, 3.93%, 17.20%, and 65.02%, respectively. The optimal geometrical parameters are α = 60°, r = 2 mm, and d = 15 mm, while the optimal working parameters are β = 30° and P = 800 N. In the optimal case, IA and MSE were reduced by 55.335% and 15.809%, respectively, compared to the initial case. Despite a 15.706% increase in TF, the overall GRG increased for all three evaluation criteria, with an overall increase in efficiency of 18.229%. The results of this paper can provide guidance for the design of Stinger cutter PDC drill bits. |
---|---|
ISSN: | 0034-6748 1089-7623 1089-7623 |
DOI: | 10.1063/5.0224824 |