Heat of hydration in ultralight cementitious foams incorporating metakaolin and microencapsulated phase change material

The paper presents the results of a study on the hydration heat of ultralight cementitious foams envisaged as insulation materials for building envelopes. The examined porous foam-cement material was additionally enhanced by embedded microencapsulated phase change material (PCM) to improve the desired thermal properties of the material. The heat emission and heat flow were measured at 20 °C and 30 °C for 168 h using the isothermal calorimeter. The experimental study comprised composites with dry densities of 240 kg m −3 and 480 kg m −3 , two concentrations of protein-based foaming agent (2% and 4%) and two dosages of the embedded PCM material (10% and 20%). The reference composite without PCM was also tested. The effect of the necessary admixtures used to achieve the stability of ultralight cementitious foams was also examined. The results showed that hydration in ultralight foam-cement composites is retarded, and the values of heat released are lower than those of the paste used to produce the composites. In this regard, the main factors contributing to the lower heat released and its lower rate are the excess water from the foam, the dosage of the foaming agent and the admixtures introduced to achieve the stability of the ultralight composite. The stabiliser was found to be the most retarding admixture. Considering PCM, which was added at 10% and 20% of the paste volume, a rather low influence on the course of the hydration process was observed due to the overall composition of ultralight cementitious foams specially modified for each assumed content of PCM.