Discrete Element Modeling of the Breakage of Single Polyhedral Particles in the Rotary Offset Crusher

Innovation in comminution is expected to continue unabated to address the inefficiencies that are inherent in comminution circuits. The rotary offset crusher (ROC) is a new comminution device with a promising performance potential in terms of throughput due to the enhanced speed of transportation induced by the centrifugal force of the discs. However, the processes driving the comminution of particles trapped in the conical space between the two discs of the crusher are not fully understood. To gain a better insight into the comminution process in this device, discrete element modeling (DEM) simulations were conducted to study the breakage of a single particle for the crusher operated under two different dynamic conditions, i.e., (1) a stationary top disc and (2) both discs rotating at the same speed. For both scenarios, the speed of the discs was varied between 550 and 2350 rpm. Experimental testwork was also conducted with the laboratory prototype to generate the data that were used to calibrate the breakage parameters of the Ab × t10 breakage model. Simulations were performed using polyhedral UG2 ore particles that were generated with the in-built particle generator in the DEM simulator. The simulated ROC, which is operated with both discs rotating, outperformed the ROC with a stationary top disc in terms of the specific input energy and throughput. The crusher with a stationary top disc is characterized by high shear forces (suggesting a higher wear rate), specific input energies greater than 1 kWh/t, and low throughputs (