Polyantimonic acid-based materials evaluated as moisture sensors at ambient temperature

Humidity sensors are in high demand for many applications, such as environmental monitoring and air and food quality control. Despite many inorganic and organic materials exhibit moisture sensing properties, the electrical response of many existing sensors is not stable along the time. Polyantimonic acid (PAA) is characterized by elevated proton conductivity and by high thermal stability: consequently, it is seen as promising proton conductor for usage in humidity sensing devices. In this work, for the first time, PAA-based bulk solid membranes were produced and tested as potential materials for relative humidity (RH) detection and their moisture sensitivity was evaluated. Two different amounts of binder were used for moulding the solid sensors: the ones with 10% of binder were designated as 90PAA, while the ones with 20% were named 80PAA. The structures of the solid samples were investigated by X-ray diffraction (XRD) technique, adsorption–desorption curves via Brunauer–Emmett–Teller (BET), scanning electron microscopy (SEM) and energy-dispersive spectroscopy (EDS) techniques. The electrical behaviour was examined at ambient temperature by electrical impedance spectroscopy in the entire relative humidity (RH) interval (0–100%) and in the frequency range of 40 Hz up to 60 MHz. Electrical response of the materials was correlated with the structural features of the membranes. Both 90PAA and 80PAA sensors showed total resistance 3 × 10 5 and 3.5 × 10 5 Ω at 10% RH, respectively. A linear decrease of the resistance on RH was observed in the range 30–90% RH for both sensors. The electrical response of the evaluated PAA-based sensors displays good repeatability and reproducibility: the ones with lower binder content showed higher moisture sensitivity as well as very good time stability over 1 year.