Rationing and vibration monitoring of knife refiners

The subject of the research is rationing and monitoring of the vibration of knife refiners. GOST 26493-85, specifying the permissible values of the vibration amplitude of the mills, is outdated. This standard does not take into account new designs of knife refiners and the requirements of national and international standards. It is proposed to establish two criteria for assessing the vibration state of the refiners. The first criterion normalizes the amplitude of vibration in octave strips of frequencies, while the second criterion specifies the vibration trend on the general level. It is proposed to use the vibration velocity as the measured parameter. The necessity of separating the refiners into two groups was revealed: with a disc or cone diameter up to 1000 mm and with a diameter over 1000 mm. The boundaries of zones and vibration trends are determined: good; satisfactorily; need improvement and unacceptable. After that, a decision is made to limit the functioning of these machines (prevention and stop). The introduction of standards and vibration monitoring will accelerate the transition to repairs of machines on the technical condition. Methods of rationing and monitoring can be used in other industries, for example, in the mining and metallurgical industries.