Experimental studies using minimum quantity cooling (MQC) with molybdenum disulfide and graphite-based microfluids in grinding of Inconel® alloy 718

In the paper, the results of experimental studies related with determination of the influence of the supply of a grinding fluid (GF) doped with powdered graphite and MoS 2 into the machining zone with the minimum quantity cooling (MQC) method on the course and results of the reciprocating internal cylindrical grinding of rings made from Inconel® alloy 718 have been presented. As a grinding fluid, water aerosols were used. The aerosols delivered the following into the grinding zone: water slurry MoS 2 with a concentration of 30 g/dm 3 , water slurry of graphite with a concentration of 30 g/dm 3 , 5% water solution of Syntilo RHS oil and pure demineralized water. The obtained results of carried out experiments showed that the most favorable conditions of grinding wheel operation were obtained when MQC-based delivering an aerosol of water slurry made from demineralized water doped with MoS 2 and graphite with a minimum flow rate and when delivering an aerosol of 5% water slurry of Syntilo RHS oil. It was proved that doping GF with powdered MoS 2 and graphite, with delivery in the form of an aerosol with a minimum flow rate, has a substantial influence on the intensity of clogging grinding wheel active surface (GWAS). Additionally, it has been demonstrated that the solid grease MoS 2 and graphite particles reached the area of contact of the GWAS and the machined surface effectively, actively influencing its tribological conditions of the grinding process.