Effect of medium condition change on green body density during casting and drying

The present study examined whether the optimum slurry conditions in which the green body with the highest packing fraction was fabricated were the same regardless of whether tape or slip casting methods were used. Additionally, we investigated the optimum slurry evaluation method to predict the packing fraction of each green body. Specifically, aqueous dense alumina slurries, whose particle dispersion state was changed by varying pH and the amount of dispersant additive, were prepared. After changing the pH, the optimum slurry conditions were achieved regardless of the casting method. The most suitable amount of additive dispersant differed due to the changing solution conditions during the casting and drying process; the medium of the slurry permeated into the plaster during slip casting and dried on the substrate during tape casting. Thus, in slip casting, non‐adsorbed polymers could also be permeated. Hence, it is crucial for slurry evaluation to predict the packing fraction of the slip cast body. A sedimentation test, which involved particle condensation as well as casting, was valid for the green sheet. Conversely, it was experimentally shown that the constant pressure filtration test, which involved the permeation of the medium in addition to particle condensation, was suitable for slip casting.