Influence of initial microstructure on the microstructure evolution and mechanical properties of 1.0C-1.5Cr steel in the laser surface quenching

Laser surface quenching was conducted on the 1.0C-1.5Cr steel with different initial microstructures. The effects of initial microstructure on the cementite dissolution and grain size were studied, and the distributions of temperature and stress were simulated. The results indicated that the thickness of hardened layer was larger when the initial microstructure is martensite, which is mainly because the martensite-to-austenite transformation is displacive transformation during laser heating. Within hardened layer, the volume fraction of cementite (VFC) increases with the increase of depth. For the initial microstructure composed of ferrite matrix and cementite, the refining of cementite will facilitate its dissolution, and within hardened layer, mean diameter of cementite (MDC) decreases first and then increases with the increase of depth. For the initial microstructure composed of martensite matrix and cementite, the MDC changes slightly at deeper position of hardened layer. Tensile stress will form in the heat affect zone, and due to the high sensitivity to tensile stress, the impact resistance and bending properties of spheroidized microstructure are worse after laser surface quenching. Under identical laser parameters, the impact absorbed energy of spheroidized microstructure is about 50% of tempered sorbite and 60% of martensitic microstructure, and its bending strength is about 60% of tempered sorbite, and 40% of martensitic microstructure. The impact absorbed energy can be increased by at least 26% through preheating at 160 °C. In addition, the refining of initial martensitic microstructure will enhance bending resistance.