Influence of Ti and TiH2 Additives on the Structure and Properties of Copper Alloys for Diamond Cutting Tools

The influence of titanium and titanium hydride additives on the structure, mechanical properties, and wear resistance of copper alloys intended for use as a binder of the diamond cutting tool is investigated. Powder mixtures Cu–Ti and Cu–TiH 2 are fabricated by mechanical alloying in a planetary centrifugal mill. Such treatment makes it possible to form single-phased powders of the copper-based solid solution in the Cu–Ti system and two-phased powders based on copper with uniformly distributed TiH 2 particles in the Cu–TiH 2 system. It is established that the maximal mechanical properties are characteristic of the samples of compositions Cu–2.5% Ti and Cu–10% TiH 2 (higher than for pure copper by a factor of 2.0–3.5). Hardening in such alloys is implemented according to the solid-solution mechanism and due to the formation of the Cu 3 Ti 3 O phase. Grains of this phase have higher dispersity in alloys where TiH 2 is used as the titanium-containing additive, due to which high values of the bending ultimate strength (920 MPa) and hardness (114 HB) are attained. It is established according to the results of comparative tribological investigations that samples of the Cu–10% TiH 2 composition possess the best wear resistance. The reduced wear of these samples after the test according to the “rod–disc” scheme is an order of magnitude lower than for pure copper and lower by a factor of 5 than for Cu–2.5% Ti samples.