Novel High-Strength Casting Al−Zn−Mg−Ca−Fe Aluminum Alloy without Heat Treatment

Based on the studies of its structure, as well as technological and mechanical properties, the composition and application prospects are substantiated for a high-strength aluminum Al–Zn–Mg–Ca–Fe casting alloy with no heat treatment. As the subjects of study, we have obtained alloys based on a composition of Al–5.5% Zn–1.5% Mg (wt %) jointly and separately alloyed with 0.5–1.0% Ca, and 0.5% Fe. As the reference, we used standard AK12M2, AMg6lch, and AM4.5Kd casting alloys corresponding to GOST (State Standard) 1583–93 : by means of pencil sample casting, the alloy has been tested for the tendency to form hot cracks owing to hindered shrinkage. It is shown that separate alloying with calcium and iron does not promote any improvement of crack resistance and adversely affects mechanical properties. The combined alloying with 1% Ca and 0.5% Fe makes it possible to improve the parameter of hot tearing susceptibility to the level inherent in the AMg6lch alloy. This effect is caused by the formation of eutectic calcium-containing phases, and the formation of a favorable grain structure in which there are no columnar grains. Iron in the structure of the alloy is bound in compact particles, representing a Al 10 CaFe 2 phase, which is a consequence of a nonequilibrium crystallization process occurring in the course of chill-mold casting. The formation of this phase makes it possible to reduce the amount of zinc in the (Al, Zn) 4 Ca phase and mostly to conserve the composition of the (Al) solid solution, as is indicated by similar hardness values of the base Al–5.5% Zn–1.5% Mg alloy and Al–5.5% Zn–1.5% Mg–1% Ca–0.5%–Fe alloy, as well as the superiority of these values over the hardness values of alloys separately alloyed with calcium and iron. In addition, the hardness of the promising alloy in the as-cast state is more than 20 HV higher than the hardness of branded cast alloys in the same condition. The novel alloy in the as-cast state has shown the following competitive mechanical tensile properties: σ UTS ~ 310 MPa, σ 0.2 ~ 210 MPa, and δ ~ 4%.