DNA branched junctions induced the enhanced fluorescence recovery of FAM-labeled probes on rGO for detecting Pb2

The reduced graphene oxide (rGO) could strongly adsorb and quench the fluorescence of dye-labeled single-stranded DNA (ssDNA); thus, it is widely applied in fluorescent sensors. However, these sensors may suffer from a limited sensitivity due to the low fluorescence recovery when adding the complementary DNA (cDNA) sequence. In this work, the powerful DNA branched junctions were constructed to improve the fluorescence recovery of FAM-labeled probe on rGO. In the presence of target Pb 2+ , the ribonucleotide (rA) in the substrate was cleaved specifically and the catalytic hairpin assembly of three metastable hairpins was further initiated, accompanied by the formation of DNA branched junctions. Then, the liberated Pb 2+ could be recyclable. Impressively, the DNA branched junctions not only hybridize with the FAM-labeled probes with a high efficiency, but also are significantly undesirable for the rGO. Thus, a high fluorescence recovery of FAM-labeled probe on rGO was expected. The integration of the high fluorescence recovery and dual-cycle signal amplification endows the sensing strategy with a good performance for Pb 2+ detection, including low detection limit (0.17 nM), good selectivity, and satisfactory practical applicability. The proposed DNA branched junctions offer a novel avenue to improve the fluorescence recovery of the dye-labeled probes on rGO for biological analysis.