Thermal and dynamic mechanical properties of polyethylene glycol/quartz composites for phase change materials

ABSTRACT Polyethylene glycol (PEG)/quartz (denoted as BP/Q) composites have been investigated as candidates of phase change materials (PCMs) due to their thermomechanical properties around the glass transition temperature as well as thermal properties between 30 and 600 °C. Quartz (q‐SiO2) powders were extracted from local sand in Tanah Laut, Pelaihari, South Kalimantan, Indonesia. The composites were prepared by dispersing q‐SiO2 powders in the PEG matrix followed by the wet mixing process. The thermal properties of the composites were characterized using differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA), while the thermomechanical properties were examined using a dynamic mechanical analyzer (DMA) in a three‐point bending mode around the PEG glass transition temperature range (−100–50°C). The morphology and interface bonding were investigated using scanning electron microscopy (SEM) and transmission electron microscopy (TEM). From the DSC measurement, the endothermic peak of the composites showed a shift of approximately 7–12 °C toward higher temperatures than that of the pure polymer. The melting enthalpy values (ΔHm) of the BP/Q composites covered the required PCM application range, that is, between 139 and 182 J/g. The TGA of the composites showed that thermal degradation occurs in the range of 250–450 °C. We found that solid–solid PCMs (ssPCMs) were successfully fabricated with the addition of 10 and 20 wt% q‐SiO2. From DMA characterization, the BP/Q 20 wt% composite exhibited the maximum E’ and the minimum energy dissipation (E”). Its E’ value was approximately 250 MPa more than that of the pure PEG. The glass transition (Tg) temperatures of PEG and BP/Q composites (5, 10, and 20 wt%) were around −24.5, −19.1, −17.1, and − 5.3 °C, respectively. In addition, the E” and tan δ values decreased with q‐SiO2 filler content. Furthermore, the Cole‐Cole plots of the BP/Q composites revealed a better interfacial bonding between the q‐SiO2 and the PEG matrix in the composites with higher silica content. A compact morphology was shown by the BP/Q 20 wt% composite due to high silica concentration. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019, 136, 48130. Steric effect in PEG/quartz composites results in stronger bonding and intake body.