Development of in situ system to monitor the machining process using a piezo load cell

The measurement of cutting force is one of the most frequently used techniques for monitoring machining processes. Its widespread application ranges from tool condition identification, feedback control and cutting system design to process optimization.This paper suggests another system for measuring cutting force in milling processes. Generally, tool dynamometers are taken into account for the most appropriate cutting force measuring tool in the analysis of a cutting mechanism. However, high prices and limited working space make in situ systems difficult for a controllable milling process. Although an alternative suggestion is to use an AC current from a servomotor, it is unsuitable for cutting force monitoring because of a small upper frequency limit and noise.The suggested cutting force measuring system is composed of two piezo load cells placed between the moving table bracket and the nut flange of the ball screw. It has many advantages, such as lower cost and a wider measurement range than the tool dynamometer, over using the built-in feeding system and the low-cost piezo load cell for applying a conventional machining center.This paper focuses on the performance test of a newly developed measuring system. By comparing the cutting force between the tool dynamometer and the system developed from a series of end milling experiments, the accuracy of the cutting force measurement system was verified. Linearity, transverse sensitivity and the upper frequency limit of the system were verified by experiment.