Heat transfer performance of a compact loop heat pipe with alumina and silver nanofluid

The heat transfer performance and entropy analysis are done in a compact loop heat pipe (CLHP) with Al.sub.2O.sub.3/water and Ag/water nanofluid. A compact loop heat pipe having a flat square evaporator with dimensions of 34 mm (L) x 34 mm (W) x 19 mm (H) has been fabricated and tested for the heat load ranging from 30 to 500 W. The experimental tests are conducted by keeping the CLHP in the vertical orientation with distilled water, silver (Ag)/water and aluminium oxide (Al.sub.2O.sub.3)/water nanofluid having low volume concentrations of (0.09% and 0.12%). The effect of wall and vapour temperature, evaporator and condenser heat transfer coefficient, thermal resistance on the applied heat loads is experimentally investigated and compared. The experimental results showed that the evaporator thermal resistance is reduced by 34.70% and 20.21%, respectively, for 0.12 vol% of Ag, Al.sub.2O.sub.3 nanoparticles when compared with that of the distilled water. For the same volume concentrations of Ag, Al.sub.2O.sub.3 nanoparticles, an enhancement of 34.52%, 23.7%, 39.27% and 30.8%, respectively, observed for the convective heat transfer coefficients at the evaporator and condenser. The entropy is also reduced by 19.08% and 11.58% when Ag and Al.sub.2O.sub.3 nanofluids are used as the operating fluid. From the experimental tests, it is found that the addition of small amount of Ag nanoparticles in the working fluid enhanced the operating range by 15% when compared with that of Al.sub.2O.sub.3/water nanofluid without the occurrence of any dry-out conditions.