Water Relations Parameters and Tissue Development in Somatic and Zygotic Embryos of Three Pinaceous Conifers

There is increasing interest in using somatic embryogenesis to meet the demand for high quality seedlings. However, in vitro production of propagules on a large scale depends on the optimization of the maturation and germination steps promoted by desiccation and subsequent imbibition of the embryo, respectively. It is therefore important to characterize zygotic and somatic embryos in terms of their water relations. Bound water, elastic modulus, osmotic potential at full turgor, and relative water content at turgor loss point were determined for somatic and zygotic embryos of western larch and loblolly pine and somatic embryos of white spruce at two developmental stages. These water relations parameters were derived from water-release curves obtained by suspending tissue samples in sealed vials over unsaturated NaCl solutions of known water potential. There was little difference in water relations parameters among species but marked stage dependency for bound water and elastic modulus The amount of bound water was lowest in western larch somatic embryos (0.02-0.07) and highest in zygotic loblolly pine embryos (0.10-0.18). Elastic modulus ranged from 2 5 to 6.2 MPa in somatic embryos but varied between 1 4 and 1.8 MPa in zygotic embryos. The osmotic potential was lower in somatic embryos than in their zygotic counterparts Our results show that water relations parameters are remarkably conservative across species but that, within a given species, these parameters are stage specific It would seem, therefore, that desiccation protocols might be developed for a given developmental stage and applied across a range of species without the confounding effects of differences in water relations parameters