Calibrating a Viscoelastic Sea Ice Model for Wave Propagation in the Arctic Fall Marginal Ice Zone

This paper presents a wave‐in‐ice model calibration study. Data used were collected in the thin ice of the advancing autumn marginal ice zone of the western Arctic Ocean in 2015, where pancake ice was found to be prevalent. Multiple buoys were deployed in seven wave experiments; data from four of these experiments are used in the present study. Wave attenuation coefficients are calculated utilizing wave energy decay between two buoys measuring simultaneously within the ice covered region. Wavenumbers are measured in one of these experiments. Forcing parameters are obtained from simultaneous in‐situ and remote sensing observations, as well as forecast/hindcast models. Cases from three wave experiments are used to calibrate a viscoelastic model for wave attenuation/dispersion in ice cover. The calibration is done by minimizing the difference between modeled and measured complex wavenumber, using a multi‐objective genetic algorithm. The calibrated results are validated using two methods. One is to directly apply the calibrated viscoelastic parameters to one of the wave experiments not used in the calibration and then compare the attenuation from the model with measured data. The other is to use the calibrated viscoelastic model in WAVEWATCH III® over the entire western Beaufort Sea and then compare the wave spectra at two remote sites not used in the calibration. Both validations show reasonable agreement between the model and the measured data. The completed viscoelastic model is believed to be applicable to the fall marginal ice zone dominated by pancake ice. Key Points A large data set is analyzed to quantify ocean wave attenuation in the Arctic fall marginal ice zone The attenuation data set and multiple wind and ice data sets are used to first calibration and then validate a viscoelastic ice model Calibrated model parameters depend on wind and ice data used. Results suggest dependence on the ice morphology