Looking into a laser textured piston ring-liner contact

This paper presents an experimental study into the flow behaviour of lubricant in a reciprocating contact simulating a piston ring–cylinder liner pair. The aim was to understand the effects of cavitation, starvation and surface texture, as well as the interaction between these, in order to improve automotive engine performance. A custom-built test rig was used, in which a section of piston ring is loaded against a reciprocating, laser-textured, fused silica pad representing the liner. A fluorescence microscope focusses through the silica specimen onto the contact in order to image the distribution of dyed oil. Tests were performed using a range of texture geometries and orientations, under starved and fully-flooded lubrication conditions, with measurements being compared against those from a non-textured reference. Under limited oil supply conditions, the non-textured reciprocating contact sweeps oil towards the reversal points (TDC and BDC), leading to starvation and increased friction. This issue is alleviated by the presence of surface texturing, with each pocket transferring oil from the inlet to the outlet of the contact as it passes; the result being 33% lower friction and oil distributed evenly over the liner surface. Even under fully flooded conditions, starvation is shown to occur following each reversal, as the change in sliding direction causes the cavitated outlet to become the oil-deprived inlet. This proof of cavitation-reversal-starvation, which occurs for up to the first 5% of the stroke length, depending on the lubricant’s viscosity, corresponds to regions of high wear, measured in this study and on actual cylinder liners reported in the literature. This process is also counteracted by the presence of surface texture, with each pocket depositing oil into the cavitated region prior to reversal. Fluorescence data also provides insights into other mechanisms with which different textures geometries control friction. Grooves oriented parallel to sliding direction increase friction as they appear to connect the high pressure inlet with the low pressure outlet, leading to oil film collapse. Grooves oriented transverse to sliding direction produce localised cavitation inside each pocket, which supports the theory that texture draws lubricant into the contact through the ‘inlet suction’ mechanism. These findings can aid texture design by showing how pockets can be used in practice to simultaneously control oil consumption, and reduce friction and