Unraveling the Initial Microstructure Effects on Mechanical Properties and Work-Hardening Capacity of Dual-Phase Steel

Ferritic-martensitic, dual-phase (DP) microstructures with different size, morphology, and distribution of martensite were produced by altering the initial microstructures using heat treatment and thermomechanical processing routes. It was revealed that the strength, ductility, and work-hardening rate of DP steels strongly depend on the volume fraction and the morphology of the martensite phase. In this regard, the fine-grained DP microstructure showed a high work-hardening ability toward an excellent combination of strength and ductility. Such a microstructure can be readily obtained by intercritical annealing of an ultrafine grained (UFG) microstructure, where the latter can be produced by cold-rolling followed by tempering of a martensite starting microstructure. Conclusively, the enhancement of mechanical properties of DP steels through microstructural refinement was found to be more beneficial compared with increasing the volume fraction of martensite. Finally, it was also demonstrated that the work-hardening rate analysis based on the instantaneous (incremental) work-hardening exponents might be an advantageous approach for characterizing DP steels along with the conventional approaches.