Structural and Electrochemical Study of Al2O3 and TiO2 Coated Li1.2Ni0.13Mn0.54Co0.13O2 Cathode Material Using ALD

Nanolayers of Al2O3 and TiO2 coatings were applied to lithium‐ and manganese‐rich cathode powder Li1.2Ni0.13Mn0.54Co0.13O2 using an atomic layer deposition (ALD) method. The ALD coatings exhibited different surface morphologies; the Al2O3 surface film appeared to be uniform and conformal, while the TiO2 layers appeared as particulates across the material surface. In a Li‐cell, the Al2O3 surface film was stable during repeated charge and discharge, and this improved the cell cycling stability, despite a high surface impedance. The TiO2 layer was found to be more reactive with Li and formed a LixTiO2 interface, which led to a slight increase in cell capacity. However, the repetitive insertion/extraction process for the Li+ ions caused erosion of the surface protective TiO2 film, which led to degradation in cell performance, particularly at high temperature. For cells comprised of the coated Li1.2Ni0.13Mn0.54Co0.13O2 and an anode of meso‐carbon‐micro‐beads (MCMB), the cycling stability introduced by ALD was not enough to overcome the electrochemical instability of MCMB graphite. Therefore, protection of the cathode materials by ALD Al2O3 or TiO2 can address some of the capacity fading issues related to the Li‐rich cathode at room temperature. An atomic layer deposition (ALD) process is applied to the porous Li‐rich cathode Li1.2Ni0.13Mn0.54Co0.13O2 particle for Li‐ion batteries. The ALD coated Al2O3 using TMA precursor produces a conformal coating on the particles, which is contrary to the particulate morphology of the ALD‐coated TiO2. The paper discusses the impacts of ALD surface‐protection film on the battery performance in half‐ and full‐cell configurations at different temperatures.