HT9 swelling in high burnup fast reactor fuel pin components

The irradiation-induced void swelling of HT9 stainless steel has been observed many times, but there are little data available to quantify the amount of swelling expected as a function of neutron exposure and temperature. This is further complicated by potential effects of heat-to-heat chemical variations or heat treatment conditions during fabrication. This paper summarizes the results of most of the relevant previously completed studies, then focuses on the swelling behavior of HT9 mixed-oxide fuel cladding and wrapper wire irradiated to high neutron exposures. Note that the hexagonal duct used for the ACO-3 experiment (in the Fast Flux Test Facility, or FFTF) was also made from HT9 and has been studied previously by other researchers. The cladding enables a wider range of operating temperatures. Immersion density and transmission electron microscopy were used to identify a peak in the amount of swelling located axially, just below core centerline, for both the cladding and the wire. The peak roughly coincided with a peak seen in the cladding diameter profile. The wrapper wire showed enhanced swelling compared to the cladding, likely due to over-tempering during wire fabrication heat treatment. The grains showed decreased martensitic structure and were larger in size. These data do not provide for the means to fully characterize the swelling of HT9, but do provide further insight into the factors controlling it. The onset of breakaway swelling was not indicated in this data.