High-efficiency two-dimensional Ruddlesden–Popper perovskite solar cells

Thin-film solar cells were fabricated using layered two-dimensional perovskites with near-single-crystalline out-of-plane alignment, which facilitates efficient charge transport leading to greatly improved power conversion efficiency with technologically relevant stability to light exposure, humidity and heat stress. Stable 2D perovskite-based solar cells Solar cells using hybrid organic–inorganic perovskite materials as the active layer have made great leaps in power conversion efficiency over the past few years, but they are still plagued by stability problems under photoirradiation and humidity. Aditya Mohite and colleagues have now developed thin-film planar solar cells made of layered two-dimensional perovskites that facilitate efficient charge transport and show technologically relevant stability to light exposure, humidity and heat stress. The improvement over previous similar materials comes from careful alignment of the inorganic component of the perovskite by hot-casting the perovskite film, greatly increasing its charge transport ability, and therefore the efficiency of the device. Three-dimensional organic–inorganic perovskites have emerged as one of the most promising thin-film solar cell materials owing to their remarkable photophysical properties 1 , 2 , 3 , 4 , 5 , which have led to power conversion efficiencies exceeding 20 per cent 6 , 7 , with the prospect of further improvements towards the Shockley–Queisser limit for a single‐junction solar cell (33.5 per cent) 8 . Besides efficiency, another critical factor for photovoltaics and other optoelectronic applications is environmental stability and photostability under operating conditions 9 , 10 , 11 , 12 , 13 , 14 , 15 . In contrast to their three-dimensional counterparts, Ruddlesden–Popper phases—layered two-dimensional perovskite films—have shown promising stability, but poor efficiency at only 4.73 per cent 13 , 16 , 17 . This relatively poor efficiency is attributed to the inhibition of out-of-plane charge transport by the organic cations, which act like insulating spacing layers between the conducting inorganic slabs. Here we overcome this issue in layered perovskites by producing thin films of near-single-crystalline quality, in which the crystallographic planes of the inorganic perovskite component have a strongly preferential out-of-plane alignment with respect to the contacts in planar solar cells to facilitate efficient charge transport. We report a photovoltaic efficiency of 12